DIY: From Old Dresser to Pretty Vintage Bench

Holy cow! Remember when I said we were going to do a DIY using an old dresser we found on the side of the road? No? Me neither, almost. Except that it’s been in the basement all summer long (oops), staring and waiting for us to hop to it.

Hey, we got married this year. As it turns out, that kept us busy this spring.

Well, this past weekend we got to it. And as you can imagine from the blog title, we didn’t just refinish it into a fresh new dresser.

We didn’t have a cute bench in the house yet, so we thought, why not make one? And while we’re at it, how about spending as little money as possible on it? We have lots of pallets (that we’ll use in other projects as well, I’m sure) and luckily, Miklos’s brother had a 2″x4″ or two to spare us.

vintage bench from an old dresser!

I like it!

 

What we bought:

  • Nails (a few bucks)
  • Knobs (approx. $10)
  • Panel ($8)
  • Krylon spray paint ($4.99 each x 4 = $19.96)
  • Sandpaper refill, but you might have that on hand. ($5)

Psst, if Amazon.com ships to you, here’s a 6 pack of this paint for a great deal in case you want to spray paint the inside of the drawers or the back of the bench too!

I’ll admit it took a bit more work than we had anticipated, but it wasn’t an expensive project at all, and the result was definitely worth it.Here’s a play-by-play on how we did it.

Working outside, we put a tarp under our work surface because who knows what kind of things our dogs would’ve been eating after all the deconstruction and sanding if we didn’t. Having this to wrap around it also helped when it rained Saturday night.

We pulled out the drawers (some of which will be their own DIY project upcoming) and got to work.

20130907_170400

Pulled out the drawers and stared at the dresser awhile. “Wait, how is this going to happen?”

20130907_171620

Using a small crowbar, we pried off the back of the dresser. It had water damage and was some flimsy kind of board from 1942 anyway.

20130907_171442

Here’s a better view of the dresser with the back off. We decided to cut off two layers of drawers so that it was low enough to sit on with a cushion without feeling like you’re sitting on … well, an old dresser. Here, we had pried a few of the drawer slot holder thingies (actual technical term).

Note the piece of trim we pulled off the dresser that sat lengthwise between the drawers before (there were a few of these, we saved one). This was saved to sit below the drawers at the end to close the gap and add a little decorative finesse. YES, FINESSE.

20130907_174045

Miklos used this fancy power tool because had I used it, it wasn’t going to be pretty or straight or even a viable project anymore. He cut the top off the dresser, leaving the edges atop what would be the bench ‘arms’.

20130908_131307

The top of the dresser became the bench seat, of course. Waste not, want not.

What you can only kind of see here is that before nailing the bench into place, we did a couple things.

  • Pulled out the crappy old drawer holder ledges from 100 years ago.
  • Reinforced the length and width of the dresser with some 2″x4″s, so that it is sturdy enough to hold a couple of adults of average weight or more.
  • Nailed in two 6.5″ tall pieces in between where the drawers would be, otherwise we’d have two gaps between the drawers when we were done. We stood two of these up at the back as well, for extra sturdificiation.
  • Nailed in the drawer ledge things we still needed after some careful lining up along the new 2″x4″ frame.
  • Cut down and nailed in some old pallet planks to line the hollow inside of the ‘arms’. I think we were able to keep all the nails below the bench surface, which was nice.
  • Bought a 48″x30″ panel from Rona for about $8 to use along the back. Not bad!

20130908_140430

We moved the tarp and the dresser to the grass (so as not to ruin our gazebo any more than it already is) and propped our project on some of those old pallets I mentioned earlier.

We went over the surfaces of the old dresser and the drawers with a power sander (not pictured). At this time, a bee kept dive-bombing me, the sound of the sander reminiscent of its mother, I imagine. I trapped the bee in a jar, let him get a little dopey and set him free after.

Then it was time to paint!

Krylon Indoor/Outdoor Blue Ocean Breeze

WARNING: It does not SMELL like a blue ocean breeze. Wear a mask while using this.

We used Krylon Indoor/Outdoor spray paint in Blue Ocean Breeze. I was unsure of how even this paint would turn out, but I’m so glad we used it. With enough coats (and in just under an hour of coating and re-coating with this very quick-drying paint), it worked like a (happy) dream.

We used about 3.5 cans. (Again, 1 can = $4.99 at Canadian Tire.) I know this doesn’t need to be said, but if you want smooth results, be sure to follow the instructions on the back of the can. Shake the can like crazy.

20130908_150240

After a few coats of paint, it wasn’t clear whether the un-primed panel (on the back) was going to turn out the way we wanted. However, we stayed vigilant to our benchy cause and kept on sprayin’.

20130908_152719

Here’s the bench, nearly complete! It was looking a lot more even at this point, thank goodness.

Not shown: Remember the piece of trim under the drawers that I mentioned earlier? We sprayed that separately as we had kind of forgotten about needing it… We nailed it on afterward.

20130908_161712

Above is a closer look at the new knobs we put on. (Image is clickable if you want a closer look!) These were about $3.59 each at Rona and they’re a pewter colour, which I love amidst the blue ocean breeze. I also really like the pattern on them. They add a nice vintage touch, I think.

20130908_161705

And voila! Here is is, the finished product!

From yucky old dresser to fancy new/antiquey-looking bench! It wasn’t a quick project like we thought it might be, but we did it! And for around $50, I might add. That’s my favourite! (I’m a bitΒ frugal.)

I’d like to thank the neighbours for not killing us for making noise all weekend…

So what do you think? Please leave your thoughts, and discuss any other DIY projects you’ve been up to, in the comments!

 

 

[Ed. note:Β If you’re in the States or if Amazon.com ships to you — not me, sadly — you can get a 6 pack of Blue Ocean Breeze spray paint for a great deal above.]

 

About Nikki

I've been writing since I was in kindergarten where I Crayola-markered an epic tale of a tiger and a balloon on a stack of lined papers folded into a booklet and stapled along the edge (carefully, and by my teacher). I love DIY, sewing, folksy music, animals and getting out to look at and listen to nature.
Bookmark the permalink.

11 Comments

  1. Pingback: DIY: How to Make a Beautiful Pallet Headboard for Under $30 | commatose.ca

  2. Pingback: Exhaustion apologies | commatose.ca

  3. I absolutely love this!!! Definitely adding it my list of DIY projects for the summer. Thank you so much for posting the instructions, and with pictures! I don’t even attempt things like this unless there’s pictures πŸ˜›

  4. Pingback: 77 DIY Bench Ideas – Storage, Pallet, Garden, Cushion

  5. I seen your bench and I am going to do this but I don’t understand where you are putting the 24 for added support? Please help me.

    • Glad to hear you’ll be making your own bench!

      We put the 2x4s beneath the seat part of the bench, running from back to front between drawers and along the insides of the frame. You can further stabilize by attaching them with screws or nails to additional 2x4s that you build a frame with inside the bench. Just test to make sure your drawers will still fit before trying this. We had to rip out the old drawer frames because they were too flimsy. Doing this will hold much more weight than just setting the bench back onto the regular dresser frame.

      Hard to explain, easier once you have the piece opened up in front of you. Hope that helps!

  6. So cool to see what people can do and recycle. I love this bench and am going to take your know how so people in NZ will love it too πŸ™‚

    • Thank you so much! I’d love to see any finished products if you would send me a link or a picture. It’s inspiring to look at the variations people come up with.

  7. I have an old dresser that I will attempt to make into a toy box bench πŸ™‚ with 2 grandchildren I need storage and what a great way to hide it

    • Such a great idea. Since my son was born I’ve often wished we made ours with fake drawers, a lift-up bench and some slow-closing hinges. We’ll need to do that with the next dresser. πŸ˜€ If you end up taking a picture, I’d love to see what you’ve come up with!

Leave a Reply to Nik Cancel reply

Your email address will not be published. Required fields are marked *

CommentLuv badge

This site uses Akismet to reduce spam. Learn how your comment data is processed.

  • Buy Me A Coffee